[attachment=354]Hello guys,
Im using raspberry pi 3 with 4 pin jack plug to rca cable, I have already installed bmwraspcontrol v1.9 on the pi and it is operational, so i have tested this setup on a TV and it is outputing video, but when connected to the TV module im My car (e39) There is no video output. I have tried AV mode and all posible tv formats, still there is no signal from the pi.
White and blue TV module connectors are wired as per the schematic Found in the forum, video output from pi on pins 13 and 14 - white plug, pin 17 on blue plug with 100 ohm resistor connected to gpio 7 on the pi.
I have not found reseller? Still it should output video to the nav screen even without ibus connection, right?
Ive attached pictures on the blue and white tv module connectors and how i wired them.
Any guidance from your side is appreciated.
Im using raspberry pi 3 with 4 pin jack plug to rca cable, I have already installed bmwraspcontrol v1.9 on the pi and it is operational, so i have tested this setup on a TV and it is outputing video, but when connected to the TV module im My car (e39) There is no video output. I have tried AV mode and all posible tv formats, still there is no signal from the pi.
White and blue TV module connectors are wired as per the schematic Found in the forum, video output from pi on pins 13 and 14 - white plug, pin 17 on blue plug with 100 ohm resistor connected to gpio 7 on the pi.
I have not found reseller? Still it should output video to the nav screen even without ibus connection, right?
Ive attached pictures on the blue and white tv module connectors and how i wired them.
Any guidance from your side is appreciated.