BMWRaspControl - Forum

thankyou very much for the fast ansvers. i will try this 2 files . but i wonder does the arduino take the settings from rashberry ? ( from ibus communicator)

Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk

no, arduino don't get settings from raspberry.
after addon update you must set serial device to custom.
after hex upload you should reset the settings.
you have to set with terminal. BAUD 38400
use command SET:RST
after this you can set what you like. check settings.txt

reset the settings from raspberry (ibuscomminicator) ? terminal command shoul i write only "rst"

Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk

reset the arduino settings with set:rst. rst alone is unkown command.

hi . is this true for reset arduino? and then how can i select settings

Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk

this is not the current firmware at arduino

aa when i try to uploading the firmware with xloader to arduino xloader write uploading for a long time it stuck

Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk

try this xloader. https://github.com/harryberlin/Arduino-B...d_nano.zip
if you get an error too, use the upload cmd file. open in editor and edit the serial port and save file. after this drag drop the hex file to cmd.

ok i will try this. my arduino nano is clone is there ani problem with this

Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk

no, sometimes the xloader has problems. and avrdude was an old version. last one is latest release.

---

and there are differences between nano and nano (old bootloader)