BMWRaspControl - Forum

ok my nano is old bootloader anyway i make some changes on the cmd file now that is ok. now i connect with the terminal but i cannot understand how can i do the settings

Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk

+CR by send button activeted?

ok you are great i make reset and i understand how can i change the settings. i want to try this on the car

Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk

there is a settings.txt inside the zip file.
feel free to open and read.

how can i write anything on ike display welcome text for example i want to write BMW X5 and for ntsc to turn on the display is the pin 5 to arduino
and for rearcam is the gpio7 to raspberry is it true

Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk

SET:WEL_MSG:1
SET:WEL_MSG_T:BMW X5

if the raspberry is in arduino mode, you only need the arduino pin 5. the rasp sends a command to arduino for activating the pin.

never heard something about your rearcam. but i think it working also with pin5 from arduino.

what is the parameters ntwc , ntwm,
obc_display
heat_ffb
does the settings of the raspberry (ibuscommunicator) with the arduino interface works? for example if i have welcome lights dissabled on arduino settings and enabled o raspberry the welcome lights will working or no?

Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk

car network E46, E39, and so on (gets the arduino automaticly)
network mode (for different groundmodul messages)
heat ffb for control aux heating with remote key
lights control on raspberry has no effect.

hi i connect the arduino after reset but it cannot emulate cdc or write msg on ike display or comfortblik

Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk

are you sure the ibus connection of the arduino is ok and working?