Seiten: 1 2 3 4 5 6 7 8 9
yes .raspberry and ibus is disconnected when flashing maybe i dont have tx cominication
Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk
can you try to upload a simple sketch with arduino ide?
yes ofcorse all the ino files uploadin succsessful
Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk
can you edit the baudrate to 56000 in cmd and upload the hex file?
wit 56000 baudrate i have this problem
Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk
can i convert this hex to .ino for upload with the arduino software
Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk
what can i try
Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk
attached file below with baud 57600. upload is working in my case.
flash and verifikation ok no problem but no cdc emu and others . only rx no tx
Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk
(21.10.2018, 13:50)greeks schrieb: [ -> ]flash and verifikation ok no problem but no cdc emu and others . only rx no tx
Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk
and nx code
Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk
nx means, the message was not sent to ibus.
i think there is a problem with your connection between arduino and mcp2025 or mcp2025 and ibus. the other pin D13 to enable the mcp is connected?
ooo i see 3 times the schematic but i cant see this pin ok thats right now
Στάλθηκε από το ONEPLUS A3000 μου χρησιμοποιώντας Tapatalk
is it working completely now?
Seiten: 1 2 3 4 5 6 7 8 9